To remove the engine from the frame, follow these steps:
remove the chain,
disconnect the exhaust system from the engine,
remove the carburetor from the suction port of the cylinder,
disconnect the electrical cables from the terminals,
disconnect the clutch cable from the engine,
unscrew the four nuts and remove the four bolts securing the engine to the frame,
slightly lift the engine up, slide it to the side and completely remove from the frame.
1. Removing the chain, please do the following:
put the engine in the neutral position and the motorcycle in the central footrest
by turning the rear wheel, set the chain so that the hitch is in the most convenient place to remove it
, remove the spring pin of the connector by moving up
, remove the link cap and pull out the clutch, releasing the chain
by turning the rear wheel backwards (in the opposite direction engine movement), completely disconnect the chain from the motorcycle.
2. Disconnect the exhaust system from the engine. Perform the following steps:
Use a wrench to unscrew the exhaust pipe nut
. Partially unscrew (loosen) the clamping screw of the plug connecting the muffler to the exhaust pipe
. Turn the exhaust pipe slightly to the right
3. Removing the carburetor, perform the following steps:
use a screwdriver to slightly loosen the screw holding the carburetor plug on the suction pipe of the cylinder.
Disconnect the flexible hose from the fuel valve after turning off the mixture
, grasp the carburetor with your hands and turn it at a small angle in both directions, slowly pulling back until it completely exits the suction pipe of the cylinder.
4. Disconnecting the wiring harness There are three clips on the front surface of the right side of the motor housing that fix the wiring. If you want to disconnect the cables from the motor, you should:
mark the connection points of the individual cables to avoid assembly errors
unscrew the wire clamp nuts
, remove the ends of the wires
, screw the nuts onto the threaded bolts of the mounting clamps, but do not tighten them too tightly
5. Detaching the clutch cable from the engine To detach the clutch cable from the engine:
loosen the bolt securing the fixed chain guard to the side cover of the drive sprocket with a wrench.
Use a screwdriver to unscrew the three screws that secure the side cover of the sprocket to the right engine housing.
disconnect the clutch cable from the lever on the left side of the steering wheel (the method is given when removing the steering wheel)
remove the adjusting bolt from the side cover of the sprocket and remove the clutch cable from the recess.
turn the already loosened cable 90° counterclockwise and remove it, along with the pad, from the hook of the clutch control lever (located in the side cover of the sprocket).
ATTENTION. Each engine put into operation by the manufacturer has two seals, the violation of which is inevitable when the engine is dismantled.
The first seal prevents the cylinder from separating from the engine body and is attached to a wire threaded through two holes: one in the cylinder rib and the other in the left side of the engine body.
The second seal is clamped on a wire threaded through the hole at the end of the screw rod protruding from the other side of the housing and securing the clutch cover on the left side of the engine housing. All defects in the engine (and, of course, other motorcycle components) that occur during the warranty period are eliminated free of charge by TOS (Vehicle Technical Service) stations, if the seals supplied by the manufacturer were not broken earlier. The repair conditions during the warranty period are described in detail in the warranty booklet, which is issued to the buyer by the point of sale of this car. Le code promo de 1xbet donne accès à une offre complète adaptée aux passionnés de sport et de casino. Les parieurs profitent d’un bonus de 100 % jusqu’à 130 € sur leurs mises sportives, tandis que les joueurs de casino bénéficient d’un package généreux incluant 1 950 € de bonus et 150 tours gratuits sur des machines populaires.